FORD CARS
EQUIPMENT NEEDED:
~~~~~~~~~~~~~~~~~
1 - A 6 inch piece of scaffolding - just get
a hack saw and go to
the local building site and just cut yourself a couple of peices
off…
2 - A 6 inch screwdriver.
3 - A automatic centre punch - any good
DIY shop will have one..
4 - TAPE and a piece of PLASTIC Sheeting.
METHOD
~~~~~~
Locate the car check that it isnt alarmed and
dosen’t have a crook
lock or gear locking device. If all is
ok go to the driving side and pop the quarter light
window (small
triangular window in corner) you can use either a centre punch
or a screw
driver for this….
Once you have done the window open the door and then grab the
plas
tic around the steering column and pull it off there should be the
ignition
sticking out, this is where the scaffolding bar comes in
handy. Put the scaffolding bar on the
ignition and yank it forward
it should then just snap off leaving the ignition starter
intact
just insert your screwdriver and you are away.
Get some where quite and then take
all the glass out of the window
and cover it with plastic and tape…
Add A Comment