CABLE THEFT FILE

PAY TV DECODER

MATERIALS REQUIRED

1 - Radio Shack mini-box (
#270-235)
1 - 1/4 watt resistor, 2.2k-2.4k ohm (RS #271-1325)
1 - 75pf-100pf variable
capacitor (Hard to find)
2 - F61a chassis-type coaxial connectors (RS #278-212)
12"
- No. 12 solid copper wire
12" - RG59 coaxial cable

INSTRUCTIONS
/> 1. Bare a length of No. 12 gauge solid copper wire and twist around a 3/8"
nail or rod
to form a coil of 9 turns. Elongate coil to a length of 1 1/2"
inches and form right
angle bends on each end.

2. Solder the varible capacitor to the coil. It doesn’t matter
where you
solder it, it still does the same job. The best place for it is in the center

with the adjustment screw facing upward.

Note: When it comes time to place coil in box,
the coil must be insulated from
grounding. This can be done by crazy- glueing a piece of
rubber to the bottom
of the box, and securing the coil to it.

3. Tap coil at
points 2 1/2 turns from ends of coil and solder to coaxial
chassis connectors, bringing tap
leads through holes in chassis box. Use as
little wire as possible.

4. Solder
resistor to center of coil and ground other end of resistor to
chassis box, using solder lug
and small screw.

5. Drill a 1/2" diameter hold in mini- box cover to permit
adjustment of the
variable capacitor from the outside. Inspect the device for defects in

workmanship and place cover on mini- box. Tighten securely.

6. Place device in line
with existing cable on either side of the coverter
box
and connect to television set
with the short piece of RG59 coaxial cable. Set
television set to HBO channel.

7.
Using a plastic screwdriver (non-metallic), adjust the varible capacitor
until picture tunes
in. Sit back, relax, and enjoy!!!