Mi Id

griper435 · #1 (**permalink**) 10-03-2009, 01:00 AM

I need some help on the michigan holo's and UV.

I PM'd some members hoping they could help, but decided thread would yield better results.

I have the template from the Ultimate Fake ID Guide and am going to use the materials from arcadiaid.com's ID kit ( using the teslin punchouts).

I just need some way of getting the holograms and UV seal replicated. Anyone have any good ideas? I heard using photoez would work fine with MI but how would I replicate the UV? Anyone have contacts to holo company that can replicate these?

J10New21 · #2 (**permalink**) 10-31-2009, 05:00 AM

I have a MI template created with 29 layers. Perfect. I have bought a few supplies which I wanna just mess around not to produce and use. just novelty. but its a good template. Id be happy to post an image. what do you know about the process?

griper435 · #3 (**permalink**) 10-31-2009, 05:30 AM

To start off gotta print the stuff onto teslin
use a stamp kit to make a stamp for the state outline and text
use pearlex and stamp it on the ID
use a stamp kit to make a stamp for the UV seal
use UV ink pad to make a stamp on ID
laminate with bar code
use jerms utility to encode mag stripe.

J10New21 · #4 (**permalink**) 11-05-2009, 01:29 AM

So I tried making the stamp and I keep having problems. I take the negative of what I want and print it onto transparency. Put it under the light for the 2 minutes, then the 10 after I flip it. But When I take it away to wash liquid off, everything is liquid. Occassionally Ill get an outline of the whole stamp (as in the rectangle that I cut out of transparency. Have any clue what I am doing wrong?

J10New21 · #5 (**permalink**) 11-09-2009, 09:15 AM

BTW idk if you knew but the MI ID has a 1/4" magstripe and 3/4" sig stripe. Go to holosupplies; they have laminate sheets for it. Very hard to find since must magstripes are 1/2".