You Are Here: Home » Old Forums Archive » Explosives » To Hergor

To Hergor

— Posted by OoxHighVoltagexoO on 6:48 am on Mar. 20, 2002

You guys want contributions to the site instead of idiots asking dumb questions and I contributed something fun and relatively safe compared to some of the shit on here…How my idea was unsafe or dangerous is beyond me but the sparkler gives atleast a 2 minute time to get away…Its not much worse than the CO2 Cartridge bombs on this web site or the recipe for making Nitrogen Triiodide…All of them are dangerous…WTF was so damn bad about mine…Later guys…PEACE

— Posted by Hergor on 7:57 am on Mar. 20, 2002

read my post in your topic. drilling into metal that is fastened around a heat/spark-sensitive explosive is not only dangerous but stupid. by locking your topic i hope to avoid unexperienced newbies posting similar stuff.

if you feel you can rewrite it so that it’s not a suicide-device show me and i’ll unlock the topic again…

— Posted by OoxHighVoltagexoO on 8:21 am on Mar. 20, 2002

No Jackass, I said right ABOVE the metal on the shell…You go at an angle ABOVE the metal at a downwards angle so it goes through the packing wad which is cardboard or cotton like stuff then into the powder…I think you misread what I had in that post AND / OR I neglected to mention you were drilling the hole at a down angle ABOVE the metal….Anyway whatever….I just wont contribute …Ill go over here ~~~> with the other newbies and ask stupid questions just to anger you…Have a marvelous day…PEACE

— Posted by Zambosan on 11:16 am on Mar. 20, 2002

Metal, plastic, whatever.  You’re DRILLING into a container containing a low explosive.  Sparks or not, drilling rips apart molecular bonds, and generates heat.  Dumb, dumb, dumb.  Props to Hergor for locking that garbage.

— Posted by OoxHighVoltagexoO on 11:18 am on Mar. 20, 2002

should I start a new thread or what? How do you mean SHOW YOU???

— Posted by Sicopath on 2:09 pm on Mar. 20, 2002

Making an entirely new topic to tear into a single person(who means well) is very disruptive and disrespectful of you to do.
If you want to contact someone directly, do so via email.

PS. this thread dissappears.

Leave a Comment

Scroll to top