Phone Systems Tutorial part II
Phone Systems Tutorial part II by The Jolly Roger
Part II will deal with the various types of operators, office
heirarchy, & switching
equipment.
Operators
~~~~~~~~~
There are many types of operators in
the network and the more
common ones will be discussed.
TSPS Operator:
Shitty Phone Service]
Operator is probably the bitch (or bastard,
for the female libertationists out there) that
most of us are used
to having to deal with. Here are his/her responsibilities:
1) Obtaning billing information for calling card or third number
calls
2)
Identifying called customer on person-to-person calls.
3) Obtaining acceptance of
charges on collect calls.
4) Identifying calling numbers. This only happens when the
calling
# is not automatically recorded by CAMA (Centralized Automatic
Message
Accounting) & forwarded from the local office. This could
be caused by equipment failures
(ANIF- Automatic Number
Identification Failure) or if the office is not equipped for CAMA
<I once has an equipment failure happen to
me & the TSPS operator
came on and said, "What # are you calling FROM?" Out of
curiosity,
I gave her the number to my CO, she thanked me & then I was
connected
to a conversation that appeared to be between a frameman
& his wife. Then it started
ringing the party I wanted to
originally call & everyone phreaked out (excuse the pun). I
immediately dropped this dual line conference!
You should not mess with the TSPS
operator since she KNOWS which
number that you are calling from. Your number will show up on
a
10-digit LED read-out (ANI board). She also knows whether or not
you are at a
fortress phone & she can trace calls quite readily!
Out of all of the operators, she is
one of the MOST DANGEROUS.
INWARD operator:
This operator assists your
local TSPS ("0") operatorin connecting
calls. She will never question a call as
long as the call is
withing HER SERVICE AREA. She can only be reached via other
operators or by a blue box. From a blue box, you would dial
KP+NPA+121+ST for the INWARD
operator that will help you connect
any calls within that NPA only. (Blue Boxing will be
discussed in
a future file).
DIRECTORY ASSISTANCE Operator:
This is
the operator that you are connected to when you dial: 411
or NPA-555-1212. She does not
readily know where you are calling
from. She does not have access to unlisted numbers, but
she DOES
know if an unlisted # exists for a certain listing.
There is also a
directory assistance operator for deaf people who
use teletypewriters. If your modem can
transfer BAUDOT [(45.5
baud). One modem that I know of that will do this is the Apple Cat
to find... but if you
wanna do this.. look around!) then you can
call him/her up and have an interesting
conversation. The # is:
800-855-1155. They use the standard Telex abbreviations such as GA
for go ahead. they tend to be nicer and will talk longer than your
regular operators.
Also, they are more vulnerable into being
talked out of information through the process of
"social
engineering" as Chesire Catalyst would put it.
<Unfortunately, they do not have access to much. I once
bullshitted with one of these
operators a while back and I found
out that there are 2 such DA offices that handle TTY. One
is in
Philadelphia and the other is in California. They have approx. 7
operators each.
most of the TTY operators think that their job is
boring (based on an official "BIOC
poll"). They also feel that
they are under-paid. They actually call up a regular DA # to
process your request (sorry, no fancy computers!)
Other operators have access to
their own DA by dialing
KP+NPA+131+ST (MF).
CN/A operators:
CN/A
Operators are operators that do exactly the opposite of what
directory assistance operators
are for. In my experience, these
operators know more than the DA op's do & they are more
susceptable to "social engeneering." It is possible to bullshit a
CN/A
operator for the NON-PUB DA # (ie, you give them the name &
they give you the unlisted
number. See the article on unlisted
numbers in this cookbook for more info about them.). This
is due
to the fact that they assume that you are a fellow company
employee.
Unfortunately, the AT&T breakup has resulted in the
break-up of a few NON-PUB DA #'s and
policy changes in CN/A
INTERCEPT Operator:
The intercept operator is the
one that you are connected to when
there are notenough recordings available to tell you that
the #
has been disconnected or changed. She usually says, "What # you
callin'?" with a foreign accent. This is the lowest operator
lifeform. Even though they
don't know where you are calling from,
it is a waste or your time to try to verbally abuse
them since
they usually understand very little English anyway.
Incidentally, a
few area DO have intelligent INTERCEPT Operators.
OTHER Operators:
And
then there are the: MObile, Ship-to-Shore, Conference, Marine
Verify, "Leave Word and
Call Back," Rout & Rate
(KP+800+141+1212+ST), & other special operators who have
one
purpose or another in the network.
Problems with an Operator> Ask to
speak to their supervisor... or
better yet the Group Chief (who is the highest ranking
official in
any office) who is the equivalent of the Madame ina whorehouse.
By
the way, some CO's that willallow you to dial a 0 or 1 as the
4th digit, will also allow you
to call special operators & other
fun Tel. Co. #'s without a blue box. This is ver rare,
though! For
example,212-121-1111 will get you a NY Inward Operator.
Office
Hierarchy
~~~~~~~~~~~~~~~~
Every switching office in North America (the NPA
system), is
assigned an office name and class. There are five classes of
offices
numbered 1 through 5. Your CO is most likely a class 5 or
end office. All long-distance
(Toll) calls are switched by a toll
office which can be a class 4, 3, 2, or 1 office. There
is also a
class 4X office callen an intermediate point. The 4X office is a
digital one
that can have an unattended exchange attached to it
(known as a Remote Switching Unit
(RSU)).
The following chart will list the Office #, name, & how many of
those office exist (to the best of my knowledge) in North America:
Class Name Abb #
Existing
----- ----------------------- --- -----------------
> 1 Regional Center RC
12
> 2 Sectional Center SC 67
> 3 Primary Center PC 230
> 4 Toll Center
TC 1,300
> 4P Toll Point TP n/a
> 4X Intermediate Point IP n/a
> 5 End
Office EO 19,000
> 6 RSU RSU n/a
When connecting a call from one party to
another, the switching
equipment usually tries to find the shortest route between the
class 5 end office of the caller & the class 5 end officeof the
called party. If no
inter-office trunks exist between the two
parties, it will then move upward to the next
highest office for
servicing calls (Class 4). If the Class 4 office cannot handle the
call by sending it to another Class 4 or 5 office, it will then be
sent to the next highest
office in the hierarchy (3). The
switching equipment first uses the high-usage interoffice
trunk
groups, if they are busy then it goes to the fina; trunk groups on
the next
highest level. If the call cannot be connected, you will
probably get a re-order [120 IPM
(interruptions per minute) busy
signal] signal. At this time, the guys at Network Operations
are
probably shitting in their pants and trying to avoid the dreaded
Network Dreadlock
(as seen on TV!).
It is also interesting to note that 9 connections in tandem is
called ring-around-the-rosy and it has never occured in telephone
history. This would cause
an endless loop connection [a neat way
to really screw up the network].
The 10
regional centers in the US & the 2 in Canada are all
interconnected. they form the
foundation of the entire telephone
network. Since there are only 12 of them, they are listed
below:
Class 1 Regional Office Location NPA
——————————–
—
Dallas 4 ESS 214
Wayne, PA 215
Denver 4T 303
Regina No. 2SP1-4W (Canada)
306
St. Louis 4T 314
Rockdale, GA 404
Pittsburgh 4E 412
Montreal No. 1 4AETS
(Canada) 504
That’s it for now! More info to come Future update to the
Cookbook!
Have fun! -RFLAGG-